LNS Quick Load Servo 80 S2 Barfeed – 2016

LNS Quick Load Servo 80 S2  Barfeed
Specifications (subject to buyer verification):
Diameter ø 1/4 – 3-1/8” (6-80 mm)
Bar length (limited to headstock length) 14” – 63” (350 – 1600 mm)
Loading system Side load rack
Loading capacity 26” (650 mm)
Loading Front/rear
Headstock type Fixed
X or Z axis retraction 23” (600 mm)
Diameter set up 10 sec (automatic)
Total changeover 2 min (for pusher)
Motor Servo
Drive Notched belt
Parts library 500 parts program storage
Equipped With (subject to buyer verification):
Automatic diameter changing system with linear motors and LNS servo motor technology
Centerline and bar loading fingers adjust automatically as the new bar diameter is entered in the prompting
             remote HMI
No manual adjustments are required reducing changeover time to a minimum
Special Notes per LNS:  Please remember that the maximum length of bar to be run is the length of the headstock plus the length of the work holding.  A spindle liner will be required for every diameter of bar stock to be run. Also, please remember that if there is a gap over 7” between the back of the sheet metal of the lathe and the back of the spindle of the lathe, then 6” extensions on your Steel Spindle liners and an Extended Coolant Collector is required.