Takamaz XW-200 – 2000

2000 Takamaz XW-200
CNC Lathe with Gantry Loading System
Specifications (subject to buyer verification):
MACHINING CAPACITY
Maximum turning diameter ……………………………………………………………..13.14”
Maximum turning length …………………………………………………………………..8.88”
SPINDLE
Spindle speed range (infinitely variable)………………………….. 45 To 2,800 RPM
Spindle drive motor (30 minute rating) ………………………………………..AC 25 HP
Motor type……………………………………………………………………………….. AC motor
Spindle nose……………………………………………………………………………………. A2-8
TURRET SLIDE
Slide travel X axis………………………………………………………………..6.69”
Z axis…………………………………………………………………8.66”
Rapid traverse rate X axis………………………………………………………….. 944 IPM
Z axis…………………………………………………………… 944 IPM
GENERAL PURPOSE LOADER SYSTEM
Type of Grippers…………………………………………………………………………….. 3 Jaw
Maximum Work size (diameter x length)……………………7.9”x 4.72”(Standard)
Maximum work weight……………………………………………………………. 17.6 lb. x 2
Maximum Gripper stroke………………………………………………………………… 15mm
Loader slide stroke……………………………………………………………………………..5.5’
Turn device unit stroke (option) ………………………………………………………… 8mm
Type of loader control……………………………………………………………………….PMC
Type of drive unit and motion …………………………………………………………..Servo
Load/unload time (Minimum) ………………………………………………………….8 secs.
Minimum system cycle time (OP 10-20)………………………………………….. 20 sec.
TURRET TOOLING
Types of Turret clamping ………………………………………………………………….BMT
Number of tools………………………………………………………………………………. 8 x 2
Tool Hole Diameter ……………………………………………………………………………1.5”
Tool Shank Size …………………………………………………………………………………1.0”
Turret indexing time …………………………………………………………………….. 0.2 sec.

GT200 LOADER SYSTEM
Type of Grippers…………………………………………….. 3 Jaw
Maximum Work size (diameter x length)……………………………7.84”x 4.72”
Maximum work weight………………………………………….. 17.6 lb. x 2
Maximum Gripper stroke……………………………………….. 15mm
Loader slide stroke……………………………………………Depends on Spec
Turn device unit stroke (option) ……………………………… 8mm
Type of loader control…………………………………………PMC
Type of drive unit and motion ………………………………….Servo
Load/unload time (Minimum) …………………………………….8-10 sec.
Minimum system cycle time…………………………………….. 20 sec.

Equipped With (subject to buyer verification):
Fanuc 0i-TF Control
GT-200 Gantry loader (Dedicated L Hand)
Coolant system (200 lit.)
Turret X/Z
8-Station Turret by Servo x 2
Total counter & preset counter
Spindle air blow (Front)
Hydraulic Chucking Cylinder
Pneumatic operated Loader Grippers and Turn Devices
2,800 rpm spindle speed
25 horsepower AC spindle drive motor
Clear up cycle stop sequence
Middle Turn Device
0.2 Second/station turret indexing
944 IPM rapid traverse for X-axis
944 IPM rapid traverse for Z-axis
Set of Takamaz tool holders (PAGE 5)
Hinge type chip conveyor (rear mounted)