Magnum M2P250 Two Post Column Style Press
Specifications (subject to buyer verification):
Adjustable Tonnage: 50.2 tons to 251.0 tons
Daylight: 24”
Shut Height: 12”
Bed Size L-R (between pins) : 26”
Bed Size F-B (Overall) : 20”
Column Pin Diameter: 8”
Stroke Length adjustable: 1” to 12”
Rod Coupler: Sliding Shoe QCDC-10.0
Floor to Bed Distance: 32”
Approximate Ram Speeds
Rapid Advance: 126 IPM
Pressing: 17 ipm
Retract: 81 ipm
Reservoir Capacity: 120 gallons
Motor Rating: 20 H.P TEFC
Input Voltage: 230 VAC 3PH/60Hz
Approximate Foot Print: 70” wide – 38” deep – 195” high
Equipped With (subject to buyer verification):
Features Included:
Structural Designs undergo rigorous analysis through Finite Element Analysis design testing
Allen Bradley MicroLogix PLC with Panel View HMI based controls
Single Point Power Connection
2-Hand Anti-Tie-Down Start Buttons
CAT 4 Safety Start Relay
NEMA 12 enclosures
NFPA-79 / UL 508A Compliant Electrical Controls
High Temp/Low Level Warning Gauge
Magnetic Starter/ Electronic Overload
Lockable Disconnect
Press mounted controls. Pedestal mounted available.
Primary power flow for press functions is handled by a CAT 4 two-hand anti-tie down safety relay. This specialty relay checks complementary inputs from each cycle initiator to insure the operators hands are out of the work area.
Top Stop Over-Run allows press to bypass top stop RAM setting in setup modes
Pressure and Distance Reversal Mode allows operator to select between pressure or position reversal
All wiring is terminated to spring cage style terminals. These terminals provide reliable vibration resistant connections. Wiring on the panel is routed through wire troughs with removable covers.
All PLC I/O points are also terminated to the terminals. Systems include multiple guard terminals already installed. Inputs and outputs have all necessary connections (power for proximity switches and grounds and neutrals for coils) on a single terminal, no searching for support wiring for devices.
All valve coils use DIN 43650 connections with power indicator lighting and electrical EMF surge suppression.
A simple, removable and easily serviceable press mounted press hydraulic system powers the press
The heart of the hydraulic system features an efficient steel manifold designed to consolidate valving, reduce plumbing, eliminate leaks, minimize pressure drop and provide maximum service life.
Efficient Screw In Cartridge Valves (SICV) solenoid valves have extremely low leakage, low
pressure drops, low cost low current operation and simple maintenance. Piloted DIN logic elements outperform large piloted spool valves in leakage, flow and response time. Valve shift times are 30% of comparable piloted spool valves resulting in increased press cycle speeds.
Manifold System offers redundant safety feature which requires 3 solenoids to be energized before there can be any movement of the RAM in extend or retract. Failure of any single component will result in no hazardous motion of press RAM.
Electro-Hydraulic Decompression with FAST ACTING 3 stage decompression offering resistance to damaging decompression pressure spikes that is far superior to hydraulic or mechanical decompression used in other presses.
All final pressure connections use Flat Face O-Ring Hydraulic Connections to provide the most leak resistant hydraulic system. No metal to metal pressure connections and no pipe thread are used.